|
|
Linkman：Mr Yao
Phone：+86 139-1311-7336
Tel：+86 512-62896308
Fax：+86 512-62896307
Email：[email protected]
Address：58# Xinjiang Road Shengpu Town Suzhou Industry Park Suzhou China
|
|
|
|
News
Where are you now:
HomePage
>> News>> Technical safety lathe operating rules
|
Technical safety lathe operating rules
[Add Time]
2014-05-28
[Author]
This web site
[Return]
|
(1) before the work according to the provisions of the lubrication of the machine tool, check each handle is in place, and the local train the test run five minutes, confirm that all the normal operation can.
(2) chuck chuck to prison, boot wrench can not stay in the chuck or chuck.
(3) the workpiece and tool clamping to the firm, the cutter bar should not put out too long (boring except); small enough to turn to stop, prevent Tool Collision chuck, workpiece or cut hand.
(4) the operation, the operator can not stand the body does not rely on the workpiece, lathe, feet do not tread plate.
(5) when high speed cutting, should use the chip breaker and block the screen.
(6) prohibit the brake, the car back and stop to have a smooth.
(7) to remove iron, use brush or a special hook.
(8) used a file to polish workpieces, must hand in front, the left hand; emery cloth polishing workpiece, should use the "clip" and other tools, in order to prevent injuries.
(9) all should put safe position in the vicinity of the employment, volume, cutting tools, tidy and orderly.
(10) lathe without stop, forbidden to take the workpiece or the measurement of workpiece in front of.
(11) the lathe work, prohibit open or remove protection device.
(12) near work, should be clean and wipe the lathe, and the tailstock slip board box and withdrew to the right end of the bed.
|
|
|
|
|
|
|
