|
|
Linkman：Mr Yao
Phone：+86 139-1311-7336
Tel：+86 512-62896308
Fax：+86 512-62896307
Email：[email protected]
Address：58# Xinjiang Road Shengpu Town Suzhou Industry Park Suzhou China
|
|
|
|
News
Where are you now:
HomePage
>> News>> Bench work safety operation procedures
|
Bench work safety operation procedures
[Add Time]
2014-05-28
[Author]
This web site
[Return]
|
3, in the vise clamping workpiece, be forced to close, the handle to the end.
4, the hammer must be fitted firmly, and always check whether the loosening in use.
5, the use of hammer, around people, to avoid, avoid injury.
6, chipping, to control the chip flying direction, so as not to hurt.
(5) prohibited the use of sessile file, blade, blade, so as not to hurt the hand.
(6) should be set on the clamp stage protective net, work in the application of brush cleaning chip, not hand wipe the touch or blow with the mouth chip.
(7) when drilling, hand cannot contact the drill spindle and bit, it is forbidden to wear gloves, sleeves, and prevent hair was caught.
(8) fitter tools, measuring tools, should be appropriate to place on the table, so as not to fall off and damage.
7, the work site should be kept clean and tidy, aisle smooth, rough and components stacked neatly.
To make a long story short, a eight knife, knife knife see iron pin. Is technology!
|
|
|
|
|
|
|
